Your vehicle / Your equipment
Toyota Prado4WD & equipment guide
Get familiar with the Prado’s full-time 4WD layout, rear storage, rooftop tent and touring equipment before your WA road trip.

On this page
Use this with your pickup handover. Confirm the supplied vehicle’s build, fitted controls, load limits and equipment. Follow its owner’s manual and hire terms. Read while parked safely; the collection walkthrough does not replace practical 4WD training.
01 / Know your vehicle
Understand the 4WD controls
The Prado’s full-time 4WD layout needs a different explanation from a ute with a 2H selector. Identify the actual labels on the supplied vehicle before using this overview; the build year and grade determine the controls and assistance systems.
High range, centre unlocked
On a full-time Prado, all four wheels are driven during normal travel. The centre differential allows the front and rear axles to turn at different speeds. H4 is a common high-range label; it does not mean a part-time ute’s locked 4H.
Low range
L4 adds reduction gearing for controlled low-speed work. It is a transfer setting, separate from selecting a lower gear in the automatic transmission. Use the exact range-change procedure demonstrated for your Prado.
Centre differential lock
This links front and rear axle speeds for suitable low-traction conditions. It is not the normal dry sealed-road setting. Confirm engagement and return to the correct unlocked road setting before normal sealed-road travel.
Rear lock & terrain aids
A rear axle lock is separate from the centre lock. Crawl Control, terrain selection and other assistance vary by grade and year. A button mentioned in another Prado guide may not exist on your vehicle.
Use Toyota Australia’s manual finder with the actual vehicle details. This overview explains the system; it does not prescribe a switching sequence for an unidentified model.
02 / Do this at collection
A practical pickup walkthrough
Work through these actions with Zone staff. Ask for another demonstration until you can identify the controls and secure the equipment yourself.
- Identify the high/low range selector and centre-lock switch, then point out their dashboard indicators.
- With Zone staff, practise the permitted change into low range and back to the normal road setting. Record the required stop, brake and transmission steps from that vehicle’s manual.
- Open and close the rear door, carrier and drawers. Check how each latch locks for travel, keeping hands clear of moving carriers.
- Set up and pack down the tent and 270° awning with staff. Locate every travel latch, strap, pole, peg and ladder lock.
- Locate the compressor switch and hose connection, pressure gauge, tyre deflator, spare-wheel tools and the correct recovery points.
03 / The fitted setup
Use the equipment with a routine
These details come from the Toyota Prado hire listing. The handover confirms the exact equipment and instructions for your booking.
Rear door, carrier & drawers
The hire listing includes a Kaymar rear bar with dual wheel carrier and an ARB drawer system. Allow clear space behind the vehicle before opening them. Keep heavy loose items low and secured, and close and check every latch before moving. Do not assume the rear camera can see around open equipment.
ARB 44L fridge
Check the fridge’s power feed and displayed temperature at pickup. Keep vents clear and secure food so it cannot obstruct the lid or slide. If the fridge stops, note the error or battery reading before contacting Zone; do not bypass its protection settings or rewire the supply.
Rooftop tent & 270° awning
The tent sleeps two; the vehicle’s five seats do not provide five sleeping places. Choose firm, suitable ground with safe ladder access and space for the awning. Follow the supplied equipment’s securing and weather instructions. Pack away before conditions exceed those limits.
Fuel, power & tyres
The listed setup includes a 150L dual fuel tank, auxiliary battery system, 200W solar panel and ARB twin compressor. Confirm the filler arrangement, usable fuel plan and power controls at handover. Tank capacity does not establish a safe touring range, and solar output is weather dependent.
Before opening the rear setup
Park securely and leave enough room for the carrier and door to swing. Place everyday essentials where you can reach them without unloading everything. Check carrier, drawer and fridge-slide latches again after corrugated-road sections.
Camp safety: WA guidance on outdoor gas appliances. Use the manufacturer’s instructions for the actual tent, awning, stove and electrical equipment.
04 / Prepare before the surface changes
Tyres, terrain & the return to road
Before permitted sand or rough tracks
Check access, current conditions and the restrictions in your agreement. Confirm the appropriate settings and pressure instructions for your tyres and load. Locate a safe preparation area and make sure you can reinflate.
If wheelspin starts digging the vehicle in, stop repeated attempts and reassess. Recovery points and boards do not make an unfamiliar recovery safe.
Sand driving preparationBefore normal sealed-road travel
Reinflate to the instructed road pressures and restore the correct road-driving mode. Check tyres for damage, re-secure loose equipment and resolve warnings before continuing.
A warm tyre reading is not directly comparable with a cold-pressure figure. Follow the supplied pressure-check instructions.
Tyre pressure decision guideNo generic PSI figure applies to every hire. Record the pressures and adjustment limits for the actual vehicle at collection. The fitted tyre, load, speed and surface all matter.
Suitable, legally open public roads and formed public tracks do not need separate approval merely because they are unsealed or remote. Specific route restrictions and your agreed booking conditions still apply. See hire terms, sections 10–14.
05 / Before moving
Your pack-down & departure check
- Centre differential and range controls are back in the appropriate road setting.
- Rear carrier, door, drawers and fridge slide are shut and positively latched.
- Tent, ladder and awning are fully packed and all travel closures checked.
- Fridge ventilation is clear; loose kitchenware and luggage cannot move.
- Tyre pressures, fuel, drinking water and the day’s route have been checked.
Your handover record — save these details before departure
- Vehicle & manual
- Registration, model/build, transmission and the matching owner’s manual.
- Tyre instructions
- Fitted tyre size; front/rear cold road pressures for your load; any approved surface adjustment and speed limits; reinflation plan.
- Driving settings
- Normal road mode; range-change steps; what confirms engagement; how to restore normal settings.
- Equipment & clearance
- Loaded height, load limits, fuel type, power controls, equipment limits and travel-latch locations.
- Route & help
- Required approvals, agreed itinerary, check-in arrangements and the assistance contacts supplied with your hire.
Save this page and your completed handover notes before leaving reception. Keep a paper or offline copy; this website does not store your vehicle details.
06 / Common questions
Prado questions
Why can’t I follow a Ranger’s 2H instructions?
A full-time Prado drives both axles in its normal road setting and uses a centre differential. A part-time ute’s selector works differently. Match the manual and dashboard labels to the vehicle you collect.
Is the rear-mounted wheel carrier a recovery point?
Do not use a carrier, tow ball or tie-down point for recovery. At pickup, have Zone identify the fitted rated recovery points and explain the approved assistance process. Equipment ratings do not replace recovery training.
Can five people sleep in the Prado setup?
The current hire configuration has five passenger seats and a rooftop tent sleeping two. Arrange separate sleeping equipment for additional travellers and include all equipment and passengers in the load plan.
If something is unclear
Stop safely. Get the right help.
Vehicle or equipment problem
Stop using unsafe equipment and contact Zone. Note the location, warning message and what happened. Seek approval before non-emergency repairs or recovery.
During working hours:
+61 8 6256 4519
After hours:
info@zone4wdhire.com.au
Use any additional assistance contact supplied with your hire. Location and service availability affect response arrangements.
Immediate danger
Call 000 for an urgent threat to life or safety. Mobile emergency calls still need an available network; plan suitable remote communications before leaving coverage.
Emergency & recovery adviceEmergency information: ACMA. Prepared by Zone 4WD Hire · Updated 14 October 2026. Equipment reflects the current hire listing; confirm your booked setup at collection.
