Your vehicle / Your equipment
Ford Everest Platinum4WD & equipment guide
A practical guide to the 2025 Everest Platinum hire setup: driving-mode choices, the rooftop tent, 180° awning and rear fridge and drawers.

On this page
Use this with your pickup handover. Confirm the supplied vehicle’s build, fitted controls, load limits and equipment. Follow its owner’s manual and hire terms. Read while parked safely; the collection walkthrough does not replace practical 4WD training.
01 / Know your vehicle
Understand the 4WD controls
Our listing identifies a 2025 Everest Platinum. Confirm the supplied vehicle and its displayed mode options at collection. A terrain mode and a transfer mode are related controls, so check the dashboard after changing either.
2H
High-range drive to the rear wheels. Follow the supplied vehicle’s normal-road mode instructions.
4A
Where shown, automatic four-wheel drive varies drive to the axles as needed. It can be used for appropriate on-road conditions; it is different from locked 4H.
4H
High-range four-wheel drive for suitable low-traction conditions. Ford specifies that this is not a dry-pavement setting.
4L
Additional reduction gearing for slow off-road work. Follow the matching manual’s stop and transmission requirements before shifting; confirm completion on the display.
A terrain selection can change other settings
Check the indicated 4WD mode after choosing a terrain mode. A flashing mode indicator can mean the shift is still in progress. Resolve an incomplete shift or warning before tackling a difficult section.
Sources: Ford Australia’s 2025 Everest manual finder; Australia/NZ Everest handbook, 4WD principles pp. 184–189. Select the exact build’s manual for operating steps.
02 / Do this at collection
A practical pickup walkthrough
Work through these actions with Zone staff. Ask for another demonstration until you can identify the controls and secure the equipment yourself.
- Find 2H, 4A, 4H and 4L on the supplied vehicle and identify the confirmed-mode display.
- Have staff demonstrate a low-range change and return to road settings, using the matching manual. Repeat the procedure with supervision.
- Ask which terrain modes, differential lock and descent assistance apply to your itinerary, and how to restore the normal road settings.
- Open the tailgate, fridge slide and drawers. Check clearance and locate every travel latch before loading luggage.
- Practise setting up and packing the rooftop tent and 180° awning, then locate the twin compressor controls and gauge.
03 / The fitted setup
Use the equipment with a routine
These details come from the Ford Everest Platinum hire listing. The handover confirms the exact equipment and instructions for your booking.
ARB 60L fridge & rear drawers
Locate the fridge power control, temperature display and travel lock. Leave its ventilation space clear. Pack items so the drawer and slide can latch completely. If the fridge stops, note the displayed message and battery reading; contact Zone before changing protection settings.
Rooftop tent for two
The hire vehicle is configured for five passengers; the tent sleeps two. Keep a clear, stable ladder landing area and follow the fitted tent’s ladder and load instructions. Before driving, check the tent perimeter, cover, latches and straps from outside the vehicle.
180° awning & cooking
The listed awning opens around the side/rear camp area. Check clearance before deployment and use the supplied securing system as demonstrated. The Coleman stove is an outdoor appliance: use it in open air, away from the vehicle and tent, subject to fire restrictions.
Auxiliary power & inflation
The listing includes an auxiliary battery system, 200W solar panel and ARB twin compressor. Ask which outlets use auxiliary power and how to read the monitor. Do a short supervised inflation demonstration so you know the hose connection, switch and equipment limits.
Leave room for the rear camping area
Park where the tailgate can open fully without contacting branches, the tent or other equipment. Keep a clear path between the fridge, cooking area and ladder. Before moving, walk around the whole vehicle and check overhead clearance with all roof equipment closed.
Camp safety: WA guidance on outdoor gas appliances. Use the manufacturer’s instructions for the actual tent, awning, stove and electrical equipment.
04 / Prepare before the surface changes
Tyres, terrain & the return to road
Before permitted sand or rough tracks
Check access, current conditions and the restrictions in your agreement. Confirm the appropriate settings and pressure instructions for your tyres and load. Locate a safe preparation area and make sure you can reinflate.
If wheelspin starts digging the vehicle in, stop repeated attempts and reassess. Recovery points and boards do not make an unfamiliar recovery safe.
Sand driving preparationBefore normal sealed-road travel
Reinflate to the instructed road pressures and restore the correct road-driving mode. Check tyres for damage, re-secure loose equipment and resolve warnings before continuing.
A warm tyre reading is not directly comparable with a cold-pressure figure. Follow the supplied pressure-check instructions.
Tyre pressure decision guideNo generic PSI figure applies to every hire. Record the pressures and adjustment limits for the actual vehicle at collection. The fitted tyre, load, speed and surface all matter.
Suitable, legally open public roads and formed public tracks do not need separate approval merely because they are unsealed or remote. Specific route restrictions and your agreed booking conditions still apply. See hire terms, sections 10–14.
05 / Before moving
Your pack-down & departure check
- Normal road/terrain settings are restored for the next surface.
- Tailgate, drawers and fridge slide are fully closed and latched.
- Tent, ladder, awning and all travel straps are packed securely.
- The fridge is running as expected and its air vents are unobstructed.
- Roof height, tyre pressures, water, fuel and the day’s route are confirmed.
Your handover record — save these details before departure
- Vehicle & manual
- Registration, model/build, transmission and the matching owner’s manual.
- Tyre instructions
- Fitted tyre size; front/rear cold road pressures for your load; any approved surface adjustment and speed limits; reinflation plan.
- Driving settings
- Normal road mode; range-change steps; what confirms engagement; how to restore normal settings.
- Equipment & clearance
- Loaded height, load limits, fuel type, power controls, equipment limits and travel-latch locations.
- Route & help
- Required approvals, agreed itinerary, check-in arrangements and the assistance contacts supplied with your hire.
Save this page and your completed handover notes before leaving reception. Keep a paper or offline copy; this website does not store your vehicle details.
06 / Common questions
Everest questions
Does 4A mean I can drive faster on gravel?
No. Available grip, visibility and stopping distance still determine a safe speed. Use the appropriate mode, keep inputs smooth and follow the lower of the posted limit, hire limit and safe speed for conditions.
Can I rely on the terrain mode to choose every setting?
Check the display after selection and understand what changed. Mode availability and interactions vary. Ask for a demonstration of the mode intended for your route, including how to return to ordinary road driving.
Why does this guide say five passengers?
This describes Zone’s configured hire setup, as listed on the vehicle page. Manufacturer brochures may show other seating arrangements. Confirm the configuration on your booking; passenger capacity and tent sleeping capacity are separate.
If something is unclear
Stop safely. Get the right help.
Vehicle or equipment problem
Stop using unsafe equipment and contact Zone. Note the location, warning message and what happened. Seek approval before non-emergency repairs or recovery.
During working hours:
+61 8 6256 4519
After hours:
info@zone4wdhire.com.au
Use any additional assistance contact supplied with your hire. Location and service availability affect response arrangements.
Immediate danger
Call 000 for an urgent threat to life or safety. Mobile emergency calls still need an available network; plan suitable remote communications before leaving coverage.
Emergency & recovery adviceEmergency information: ACMA. Prepared by Zone 4WD Hire · Updated 14 October 2026. Equipment reflects the current hire listing; confirm your booked setup at collection.
